INJECT+MATIC Microinjector
INJECT+MATIC Puller
Capillaries "DRUMMOND"
Capillaries "CLARK" without filament
Capillaries "CLARK" with filament
HOLDER for capillaries
FERTY Syringe Plus
Remplacement kit for FERTY Syringe
INJECT+MATIC Sleeper
INJECT+MATIC Sleeper TAS
Sleeper Micropourous Filters
Flowbed for Sleeper
Pistol for Sleeper
Pedal for Sleeper
Transparent ring for Flowbed
INJECT+MATIC TAS+Plus
MOTIC Stereomicroscope
INJECT+MATIC TAS+Plus filtre
Products
INJECT+MATIC Puller
The INJECT+MATIC Puller produces sterile microinjection tips (1-10 microns diameter) from any type of glass capillaries. The glass tips are used to transfer a soluble material (DNA, RNA, proteins or any other biological substance) into oocytes, cells, larva or embryos for transgenic work.

The INJECT+MATIC Puller is the only instrument to use a pneumatic pulling system that ensures the regularity of the glass tubing or capillary flow.

The INJECT+MATIC Puller uses an electronically assisted heater coil temperature to manufacture reproducible tips, either for microinjection or as holding tool.

The INJECT+MATIC Puller was designed to complement the use of the INJECT + MATIC microinjector. Its ingenious screw-clamp system permits a convenient introduction of the glass capillary.